Gs2 rate controller manual

Greenstar Rate Controller / Raven – What are the common Greenstar Rate Controller and Raven calibration numbers? Cause: The following numbers can be used as a guide when setting up the speed source, control valve calibration and flow meter when using a Raven™ console or a Greenstar™ rate controller with a Raven™ system. The GreenStar Rate Controller allows the GreenStar 3 Display, / CommandCenter™ Display, and / Universal Display to integrate with anhydrous ammonia (NH3) applicators, such as the John Deere Series of nutrient applicators, self-propelled sprayers, liquid manure applicators, liquid fertilizer applicators, and many pull-type . Refer to Table to determine the water flow rate and the size and number of couplings required for your system. Flow Rate (Gal/Min) Size No. of Connections GS2-GS10* GSGS24* GSGS60** GSGS84** GSGS** GS** Confirm the type of controller used and refer to appropriate section in manual and controller manual.

ON. In the box for the rate, edit the rate and Select Rx. Select the Rate button now set for Rx and the monitor should return to the run screen and a GREEN Rx should appear beside the target rate now at the top of the screen. If a GREEN Rx symbol DOES NOT appear, the planter will plant the last manual rate used. For detailed setup instructions please refer to the GreenStar Rate Controller Operator's Manual and the GS2 Basic Operator's Manual. GS2 Rate Controller - Main nh3 lb NH3/ac lb NH3/ac mi/h gal/min Predefined 0 (%) ac/h ac/h Rate (lb NH3/ac) Rate 3 Rate 2 Rate 1 Master Off Rate Controller Rate. maintenance of this fireplace. Please familiarize yourself with the Owner's Manual before operating your heater and save the manual for future reference. Important Information No other GSR2 gas fireplace has the same serial number as yours. The serial number is on the listing label that is chained to the gas control valve. This.

Introduction OUO,FB1 AUG/1 JS,A JUL/1 www.doorway.ru NOTE. Display GS2 Rate Controller with 37 Pin Connector. Please consult your GS2 operators manual for GS2 operating instructions. System Components: The Endeavor electric pump system can be controlled from the John Deere GS2 display. A John Deere rate controller is required to do this. The rate controller is a black box which will be mounted outside the cab, usually on the implement. GS2 Rate Controller (manual control from factory) Requires GS2 Rate Controller Tru Count Clutch System CAN-based half-width disconnects** or CAN-based frame control** No No No Requires GS2 Rate Controller Tru Count Clutch System. SeedStar 2 Controllers. MY09 and newer Factory Option Requires RowCommand Requires a GS2 Rate Controller.